View previous topic :: View next topic |
Author |
Message |
Becky Senior Member
Joined: 09 Apr 2007 Posts: 83
|
Posted: Fri Aug 10, 2007 9:12 pm Post subject: removing paint? |
|
|
I recently acquired some violins from a school rental program that have the rental numbers painted on the ribs. Is there any way I can remove this without harming the finish?
Thanks |
|
Back to top |
|
|
Mat Roop Senior Member
Joined: 24 Mar 2007 Posts: 911 Location: Wyoming Ontario
|
Posted: Fri Aug 10, 2007 10:42 pm Post subject: |
|
|
Depending on the type of paint they used...I would start with a very careful scraping...with a very clean and fine edge like a razor blade... even if you take off a micro thin layer of the violin varnish, that is easily repaired... but don't get thru the color layers. You could also try sanding...but be sure the sandpaper is at least 400 grit or finer, and glued to the end of a 45 degree cleanly cut stick...about 1/4" X 1/2" .. that way the grit is easily controlled and you can focus on just the paint.
Good luck... Mat |
|
Back to top |
|
|
sonnichs Junior Member
Joined: 06 Jun 2007 Posts: 2 Location: Falmouth,MA
|
Posted: Sat Aug 11, 2007 12:04 am Post subject: |
|
|
Becky
I went through this process on some old school Pfretzschner violins. Mat is giving you good advice, however in my case the white "paint" that the school used was something, probably acetone based, that ate right into the violin varnish and seeped into the wood. I expect that this was deliberate to prevent easy removal.
If gentle methods such as Mat suggests don't work ( You may also try scotch brite which is a rather gentle sanding medium), you may have to resort to acetone, lacquer thinner or "Stripeze". That is where I finally ended up. Fortunately most schools mark the ribs or areas not as involved with the sound, and most restorers would probably agree that this is not invasive although inconvenient. I touched up with the usual methods-luckily the Pfretzschner breed seems to have a "blended" antique type finish and I was able to take advantage of this in making a blended touchup.
Regards, Fritz |
|
Back to top |
|
|
atelier Junior Member
Joined: 13 Aug 2007 Posts: 1 Location: UK
|
Posted: Mon Aug 13, 2007 9:22 pm Post subject: |
|
|
Hi Becky, I would agree with the methods mentioned by Mat and Fritz. A very light scraping on a tiny section of a painted number to establish how deep the paint goes and you may find that it does not penetrate beyond the first layer of varnish. Be careful not to enlarge the affected areas with the scraper. A good photo of the painted numbers might have been useful to see first, however proceed with care and hopefuly things will be ok and it will probably require no more than a clear varnish touch up. |
|
Back to top |
|
|
Jack H. Super Member
Joined: 24 Mar 2007 Posts: 346 Location: Israel
|
Posted: Wed Aug 15, 2007 1:12 am Post subject: |
|
|
I would start with water and then work up to the more agressive solutions like xylene and then scrapping.
Good luck though Becky.
Jack H. |
|
Back to top |
|
|
|